Getting Started; Standby / Switching On / Switching Off; Connecting Headphones; Connecting An External Audio Device - Sonoro Cubo Instruction Manual

2. Getting started

2.1 Standby / Switching on / Switching off

When the device is supplied with power, it will go into standby mode. The time in the display
will light up. To switch the device on, press STANDBY. Press STANDBY again to switch the
device off.

2.2 Connecting headphones

You can also connect headphones to the device. To do this, connect the headphones to the
jack on the rear of the device.

2.3 Connecting an external audio device

You can connect an external audio device, e.g. an MP3 player, iPod
device. Please use a suitable audio cable and connect the external device to the AUX-IN jack
on the rear of the cubo. Select AUX mode by pressing the MODE button (AUX will appear on
the display).

2.4 Connecting the antenna

Connect the antenna included with the device to the antenna jack (ANTENNA). If the radio re-
ception does not match your expectations, then you can try to improve the reception quality by
adjusting the antenna. If you have a rooftop aerial connection, you can also connect this to the
antenna jack of the device. Use an antenna connection cable, which you can obtain from a spe-
cialist dealer.

2.5 Adjusting the sound (bass / treble)

1. Press MENu.
2. Press SkIP until Set-Tone appears on the display.
3. Press MENu again and set the bass level using the volume controls.
4. Press SkIP again to set the treble levels.
5. Confirm your selection by pressing

2.6 Pairing the remote control

1. Insert a lithium battery (button cell type CR2032) into the remote control with the +pole
facing upwards and close the sliding cover.
2. Press STANDBY on the device to switch it off.
3. Press and hold
4. Then press and hold
After pairing is completed, "Pairing" appears on the display.
6
AVL DESCHAMPS - Benedictijnenstraat 34 - 8970 Poperinge - T. 0475/97 90 20 - E. stephan@avldeschamps.be - W. www.avldeschamps.be
MENu.
REVERSE (SkIP) and VOLuME+ until "Remote" appears in the display.
MODE and TuN+ on the remote control to pair the remote control.
® , Notebook or similar