Getting Started; Unpacking Sonorostream; Connecting The Power Supply; Inserting The Battery In The Remote Control - Sonoro STREAM SO-410 Operating Manual

3

Getting started

3.1

Unpacking sonoroSTREAM

1. Take sonoroSTREAM out of the packaging and check whether
sonoroSTREAM or the individual parts exhibit damages. If this is the case, do
not use sonoroSTREAM. Should you detect any damage, contact your dealer
or sonoro audio GmbH customer support immediately.
2. Check to make sure that the delivery is complete (see chapter "Scope of
delivery").
3. Place sonoroSTREAM at a suitable location. If you want to put your
sonoroSTREAM on a natural wood surface, please make sure that it is
suitable. On oiled and waxed surfaces may possibly cause stains
4. Remove the protective film from the display.
3.2

Connecting the power supply

1. Insert the connector of the power adapter into the DC power input jack on
the back of sonoroSTREAM.
2. Insert the power plug into a wall socket. sonoroSTREAM is turned on.
Remove the protective cover before inserting the DC connector.
3.3

Inserting the battery in the remote control

1. Open the battery compartment cover on the back of the remote control by
turning it anticlockwise using a small coin.
2. Insert the supplied batteries (CR2025, 3 V) with the label (+) side up.
3. Replace and close the battery compartment cover by turning the cover
clockwise using a small coin.
© sonoro audio GmbH 2019
GB
59