Section 3 - Installation; Installing To A Feeder With Power Pin; Installing To A Feeder With A Euro Or Bernard Power Pin; Installing To A Fume Extraction Unit - Bernard CLEAN AIR SERIES Owner's Manual

3-1 Installing to a Feeder with a Power Pin

3-2 Installing to a Feeder with a Euro or Bernard Power Pin

Bernard

3-3 Installing to a Fume Extraction Unit

Page 8

SECTION 3 - INSTALLATION

Euro
Fume Port
Coupler
1. Insert power pin to shoulder and
secure tightly.
2. Insert control plug into feeder.
3. Feed welding wire into power
pin by hand and tighten drive rolls.
1. Insert the Euro power pin to face of
receptacle. Thread Euro hand
nut clockwise to tighten.
1. Insert the Bernard power pin to face
of receptacle. Engage and rotate
locking sleeve to tighten
1. Thread coupler onto hose
connected to fume extraction unit.
Slide coupler onto fume port on
rear strain relief and secure by
tightening clamp.