Section 5 - Installation; Installing To A Feeder With A Power Pin; Installing To A Feeder With A Euro Or A Bernard ® Power Pin - Bernard Q20 Series Owner's Manual

5-1 Installing to a Feeder with a Power Pin

1. Insert power pin to shoulder and secure tightly.
2. Insert control plug into feeder.
3. Feed welding wire into power pin by hand and tighten drive rolls.
5-2 Installing to a Feeder with a Euro or a Bernard
A. Euro Power Pin
1. Insert the Euro power pin to face of receptacle.
2. Thread Euro hand nut clockwise to tighten.
B. Bernard Power Pin
1. Insert the Bernard power pin to face of receptacle.
2. Engage and rotate locking sleeve to tighten.
12 OM-BTB-2.4
SECTION 5 — INSTALLATION
®
Power Pin
Figure 5-A
Figure 5-B
Figure 5-C