Before Using The Miter Saw; Operating Instruction - Black & Decker SM1850BD Instruction Manual

SETTING CUTTING DEPTH (FIGURE S)
The depth of cut can be preset for even
and repetitive shallow cuts.
• Adjust the cutting head down (See
CUTTING HEAD section) until the teeth
of the blade are at the desired depth.
• While holding the upper arm in that
position, turn the stop knob (1) until it
touches the stop plate (2).
• Recheck the blade depth by moving
the cutting head front to back through
the full motion of a typical cut along the
control arm.
S
ADJUSTING CUTTING DEPTH
(FIGURE S)
The maximum depth travel of the cutting
head was set at the factory. Check to see
that the blade does not extend more than
1/4 in. below the table insert, and does not
touch the control arm throat or any part of
the base or table. If the maximum depth
needs readjusting:
• Loosen the stop knob (1) while moving
the cutting head down until the blade
extends just 1/4 in. below the table
insert.
• Adjust the stop knob (1) to touch the
stop plate (2).
• Recheck the blade depth by moving
the cutting head front to back through
the full motion of a cut along the control
arm. If the blade touches the inside of
the control arm, readjust the setting.

OPERATING INSTRUCTION

BEFORE USING THE MITER SAW

!
• To reduce the risk of injury, turn
• To avoid mistakes that could cause
• Completely assemble and adjust
1
• Learn the use and function of the
• Review and understand all safety
2
• Review the MAINTENANCE and
• To avoid injury or possible death from
BEFORE EACH USE INSPECT YOUR
SAW
• Disconnect the miter saw. To avoid
• Compare the direction of rotation
• Tighten the arbor bolt.
• Tighten the cover plate screw.
• Check for damaged parts. Check for:
19
WARNING
unit off and disconnect it from
power source before installing
and removing accessories, before
adjusting or when making repairs.
An accidental start-up can cause
injury.
serious, permanent injury, do not
plug the tool in until the following
steps are completed:
the saw, following the instructions.
(ASSEMBLY AND ADJUSTMENTS)
ON/OFF switch, upper and lower blade
guards, hold down latch, bevel lock
handle and cover plate screws.
instructions and operating procedures
in this Operator's Manual.
TROUBLESHOOTING GUIDE for your
miter saw.
electrical shock, make sure your fingers
do not touch the plug's metal prongs
when plugging or unplugging your miter
saw. (ELECTRICAL REQUIREMENTS
AND SAFETY)
injury from accidental starting, unplug
the saw before any adjustments,
including set-up and blade changes.
arrow on the guard to the direction
arrow on the blade. The blade teeth
should always point downward at the
front of the saw.
• Alignment of moving parts
• Damaged electric cords
• Binding of moving parts
• Mounting holes