Black & Decker SM1850BD Instruction Manual page 17

M
BEVEL STOP ADJUSTMENTS
(FIGURE N, O, P)
WARNING
To avoid injury from
!
unexpected starting or electrical shock,
make sure the trigger is released and
remove the power cord from the power
source.
90°(0°) Bevel adjustment (Figure N)
• Loosen bevel lock handle (1) and tilt
the cutting arm completely to the right.
Tighten the bevel lock handle.
• Place a combination square (2) on the
miter table with the ruler against the
table and the heel of the square against
the saw blade.
• If the blade is not 90°(0°) square with
the table (3), loosen the bevel lock
handle (1), tilt the cutting head to the
left, loosen the locknut (5) on the bevel
angle adjustment bolt (4) and use a
10 mm wrench to adjust the stop bolt (4)
depth in or out to increase or decrease
the bevel angle.
• Tilt the cutting arm to back to the
right at 90°(0°) bevel and recheck for
alignment.
• Repeat above steps if further
adjustment is needed.
• Tighten locknut (5) and bevel lock
handle (1) when alignment is achieved.
3/4 Inch
plywood
17
N
4
2
90° Bevel pointer adjustment (Figure O)
• When the blade is exactly 90
the table, loosen the bevel indicator
screw (6) using a # 2 Phillips
screwdriver.
• Adjust bevel indicator (7) to the "0"
mark on the bevel scale and retighten
the screw.
O
45° Bevel adjustment (Figure P)
• Loosen the bevel lock handle (1) and
tilt the cutting head completely to the
left.
• Using a combination square, check
to see if the blade angle is 45° to the
table.
1
5
3
o o
(0 ) to
6
7