Throttle - INOKIM LIGHT User Manual Manual

THROTTLE OPERATION
SPEED MODE
When power is on
SPEED
the default display is mode (appear at top right).
You may change it using the
Speed mode: this function is to limit the maximum
speed of the scooter, either for a beginner user or for
more accurate riding in a crowded surrounding:
•
speed mode 3 - using full throttle will gain maximum
speed of the scooter, 25KM/H at default.
•
speed mode 2 - using full throttle, will gain 70% of scooter top speed.
•
speed mode 1 - using full throttle, the maximum speed will be under10 KM/H
SETINGS - DISPLAY MODES
To enter the display modes setings :
Touch buttons together for 2 seconds will enter in the first mode.
Press to switch between modes
Long press will back to main function menu.
•
(
LCD BACKLIGHT first mode)
When power is on, you can open or close the LCD backlight by long press
There are 3 levels for different LCD brightness.
Press to change level from 1 to 3 (low/middle/high).
Long touch to save settings.
Short touch to enter second mode.
•
SPEED LIMIT MODE (second mode)
Default and highest speed 25KM/H at full throttle.
You can define other speed limits (from 6KM/H to 30KM/H).
Press or buttons to change speed limit number.
Long touch to save setting.
Short touch to enter third mode.
buttons.
20
THROTTLE OPERATION
DISPLAY MODES
•
CRUISE CONTROL (third mode)
The default setting is Cruise Control off (letter "n" for No Cruise Control to
indicate).
Press or to choose enable Cruise Control
to indicate Yes Cruise Control).
(Letter "Y"
Long touch to save setting.
Short touch to enter first mode.
•
TRIP RESET
Reset TRIP by long press
OTHER DISPLAY MODES ARE:
•
TRIP- your trip distance since your last trip reset. Press
•
ODO - your scooter total distance since its factory assembled,
or new / repaired battery was placed.
•
Battery voltage - Your battery state.
•
Error - your system has encountered an error, please contact your local
dealer to find out what it is.
CRUISE CONTROL
Wile riding at any same speed for more then Ten (10) seconds, the Cruise
Control will be turned on, (If this option is defined in "SETTINGS", it does not
come as a default for safety reasons).
When Cruise Control is operated, you can release your thumb from the throttle
and the scooter will continue to ride at full speed.
To slow down, simply apply pressure on one of the brake levers or press the
throttle again, the Cruise Control will be turned off.
When riding with cruise control and braking, Cruise Control system powers off.
WARNING!
Please be aware that when using Cruise Control system,
releasing your thumb from the throttle will not slow you down,
you may fined yourself in danger or in danger of others.
to swap.
21