Rangemaster classic deluxe 100 User's Manual & Installation Instructions page 32

Fig. 7.1
ArtNo.324-0005 Oven light bulb
Fig. 7.2
Fig. 7.3
ArtNo.320-0006 Oven door hinge adjustment 1
Effect of hinge adjustment – exagerrated for clarity
Fig. 7.4
Centreline of hinge pin
ArtNo.320-0007 Oven door hinge adjustment 2
Oven door omitted for clarity
The Oven light is not working
The bulb has probably burnt out. You can buy a replacement
bulb (which is not covered under the guarantee) from a good
electrical shop. Ask for a 15 W – 230 V lamp, FOR OVENS. It
must be a special bulb, heat resistant to 300 °C (Fig. 7.1).
Before removing the existing bulb, turn off the power supply
and make sure that the oven is cool. Open the oven door and
remove the oven shelves.
Locate the bulb cover and unscrew it by turning it counter-
clockwise (it may be very stiff ) (Fig. 7.2).
Now unscrew the existing bulb counter-clockwise, taking
care to protect your fingers with a glove in case the bulb
should shatter.
Screw in the new bulb clockwise and then screw the bulb
cover back on. Turn on the electricity supply and check that
the bulb now lights.
The oven door is misaligned
The bottom hinge of the left hand oven door can be adjusted
to alter the angle of the door (Fig. 7.3). Loosen the bottom
hinge fixing screws and use the notch and a flat bladed
screwdriver to move the position of the hinge to set the
hinge position (Fig. 7.4).
Retighten the hinge screws.
28