Lexus GS430 User Manual page 433

After bringing the vehicle to the desired speed, press the
control lever downward in the "– SET" direction and release it.
This sets the vehicle at that speed. At this time, the
multi−information display indicates settings such as the preset
vehicle speed, whether a vehicle is present ahead and
selected vehicle−to−vehicle distance. If there is no vehicle
detected ahead, the dynamic radar cruise control screen does
not display the vehicle ahead. At this time, you may take your
foot off the accelerator pedal. If you need to accelerate − for
example, when passing − depress the accelerator pedal
enough for the vehicle to exceed the preset speed. When you
release the accelerator pedal, the vehicle will return to the
control prior to acceleration.
You cannot set a desired speed if the master warning light
comes on, the warning tone sounds and the multi−information
display indicates a warning message such as "CRUISE NOT
AVAILABLE", "CLEAN RADAR SENSOR" or "CHECK
CRUISE SYSTEM". If any of the above messages appears on
the display, see "Vehicle−to−vehicle distance control mode
failure warning" on page 417.
If you turn off the "ON−OFF" button while the warning message
is displayed, the warning message turns off and the
multi−information display switches to another screen. If no
warning message appears on the display, when you turn the
"ON−OFF" button on again, the setting can be made.
You can change the dynamic radar cruise control screen to
another screen even while the warning message is displayed.
STARTING AND DRIVING
2 Cancelling the preset speed
You can cancel the preset speed by doing any of the following:
a. Pulling the control lever, in the "CANCEL" direction.
b. Depressing the brake pedal.
c. Pushing the "ON−OFF" button.
If cancelled by a. or b., the multi−information display shows
"RADAR READY" and the dynamic radar cruise control enters
the ready mode.
If cancelled by c., the "CRUISE" indicator light goes off in the
instrument cluster and the multi−information display shows
"CRUISE OFF". In this case, the preset speed data is cleared,
and you must set the speed from the beginning.
In the following case, the preset speed automatically
cancels out. At this time, the multi−information display
shows "RADAR READY" and the dynamic radar cruise
control enters the ready mode.
The vehicle speed falls below about 40 km/h (25 mph). (40
km/h (25 mph) is designated as a cancel speed.)
CAUTION
In this case, the warning tone reminds you that the
dynamic radar cruise control is cancelled and you must
apply the brakes to slow the vehicle.
409