Lexus GS430 User Manual page 227

Conditions for memorized position activation
D Engine switch in "IG−ON" mode and selector lever in "P"
position, with the vehicle stopped.
D Engine switch in "OFF" mode and within 30 seconds of
opening driver's door.
The memorized position can be activated, except for the tilt
and telescopic steering.
If any driving position memory switch is pushed while one of
the memorized driving position profiles is being activated, the
operation will stop.
To activate the system, push the desired button ("1", "2" or "3")
again.
The driving position memory control system cannot be
operated while the vehicle is moving.
If the vehicle's battery is disconnected, the computer's
memory will be erased and the memorized positions will have
to be set again.
CAUTION
D Do not start the vehicle while the adjustments are
being made.
D Take care not to select the wrong button, or the seat
could strike the rear passenger or hit your body
against the steering wheel. If this happens, you can
stop the movement by pressing another driving
position memory switch.
OCCUPANT RESTRAINT SYSTEMS
MEMORY RECALL FUNCTION
You can recall the memorized position using the entry
function or wireless remote control.
If you unlock the door using the entry function or wireless
remote control, the memorized seat position is recalled when
the driver's door is opened. The memorized steering wheel
position will be recalled when you push the engine switch.
This function can be used after setting by the following
procedure.
Setting the driving position onto the electronic key
The driver's door must be closed with the engine switch turned
off.
1. Push and hold the previously memorized driving position
button "1", "2" or "3".
2. While depressing the button above, push and hold the
"LOCK" or "UNLOCK" button on the electronic key until a beep
sounds.
If you wish to set other driving position, repeat the above
procedure. The previous setting will be erased and the new
position will be set.
Resetting the driving position on the electronic key
The driver's door must be closed with the engine switch turned
off.
1. Push and hold the "SET" button.
2. Push and hold the "LOCK" or "UNLOCK" button on the
electronic key until two beeps sound.
203