Panel Button Command; Paper Sensor Commands - Epson TM-U200 Information Manual

Panel Button Command

The TM-U200/U200P printers support the following command for enabling and disabling the panel
button (PAPER FEED).
Command Name
ESC c 5 Enable/disable panel button
ESC c 5 n
[Name] Enable/disable panel button
[Format] ASCII
Hex
Decimal
0 ≤ n ≤ 255
[Range]
ESC c 5 n enables or disables the PAPER FEED button. When the LSB (least significant bit) of n is 1,
this button is disabled; when it is 0, this button is enabled. To prevent problems caused by
accidentally pressing the PAPER FEED button, use this command to disable the button.
In the following cases, the panel button is enabled temporarily, regardless of the setting of this
command:
1. During the wait time set by the GS z 0 command for paper to be inserted, paper can be fed
by the PAPER FEED button.
2. During the recovery confirmation time, the PAPER FEED button is enabled, but paper cannot
be fed.
PRINT #1, CHR$(&H1B);"c5";CHR$(1);

Paper Sensor Commands

The TM-U200/U200P printers support the following command for controlling the paper sensor(s)
that stop printing.
Command Name
Select paper sensor(s) to stop printing
ESC c 4
ESC c 3 Select paper sensor(s) to output paper-end signals
Rev. A
ESC c 5
1B 63 35
27 99 53
Program Example
←
Disable panel button
TM–U200/U200P Information Manual
n
n
n
Command Descriptions 1-17