Real-Time Request To Printer - Epson TM-U200 Information Manual

ESC = n selects the device to which the host computer sends data, based on the value of n as follows:
Bit Off/On Hex Decimal
Off 00 0
0
On 01 1
Off 00 0
1
On 02 2
2-7 – – –
The printer is enabled when n = 1 or n = 3. The printer is disabled when n = 2. The default setting is
n = 1 (the printer is enabled).
When the printer is disabled, it ignores all received data, with the exception of the DLE ENQ 0 and
DLE ENQ 2 commands. Also, if ASB is enabled by the GS a command, the printer transmits a 4-byte
status message whenever the status changes.
PRINT #1, CHR$(&H1B);"=";CHR$(1);←
PRINT #1, "AAAAA";
PRINT #1, CHR$(&H1B);"=";CHR$(0);←
PRINT #1, " BBBBB";
PRINT #1, CHR$(&H1B);"=";CHR$(1);←
PRINT #1, " CCCCCC"; CHR$(&HA);
DLE ENQ n
[Name]

Real-time request to printer

[Format] ASCII
Hex
Decimal
[Range] n = 0, 2
DLE ENQ n responds to a request from the host computer specified by n as shown below. This
command is also executed when the printer is disabled. When the printer stops printing due to a
paper-end condition, n = 0 is effective only when the printer is waiting for on-line recovery from the
time the paper roll is inserted to the time the printer goes on-line.
1-34 Command Descriptions
Function
Printer disabled.
Printer enabled.
Customer display disabled.
Customer display enabled.
Undefined.
Program Example
Printer enabled
Printer disabled
Printer enabled
DLE ENQ
10 05
16 5
AAAAA CCCCC
n
n
n
Print Sample
Rev. A