Troubleshooting - D-Link DNR-322L User Manual

Section 6 - Troubleshooting
Replacing a failed disk drive
If a disk drive fails, the Disk Status LED will turn red. When replacing a failed disk drive, be sure to use a new drive of the
same or slightly greater capacity.
Step 1: Power off the NVR.
Step 2: Open the unit's cover.
Step 3: Pull out the failed disk drive.
Step 4: Install a new disk drive into the slot.
If you forget the admin password for the device
If you forget the password, you can reset the device, which will reset the password for the admin account to its
default(blank). Please note that this will reset all settings on the device back to the factory defaults, and it may cause data
corruption; it is highly recommended that you back up your recorded data before resetting your device. To reset the device,
make sure it is turned on then press and hold the reset button for 10 seconds until the Power LED flashes three times. The
Administrator password will now be blank.
If you cannot log in to the NVR using Internet Explorer
Check the settings of your anti-virus software to make sure it isn't blocking access to the NVR web interface.
If you cannot see the complete web interface using Internet Explorer
If you cannot see the complete page of the system when using Internet Explorer, the ActiveX installation process may not
be complete.
Step 1: Open Internet Explorer and connect to your NVR.
Step 2: The browser will ask whether to install ActiveX.
Step 3: Click the upper bar to begin the installation process.
Step 4: Click Install to complete the process.
D-Link DNR-322L User Manual

Troubleshooting

78