Event Settings - D-Link DNR-322L User Manual

Section 4 - Configuration
This page lets you configure what to do when an event is triggered by a
camera, such as when motion is detected. The NVR can then perform an
action, such as sending an e-mail notification.
For Camera Event Settings and System Event Settings:
Step 1: Select an event to listen for:
Connection Alert is sent when connection is lost.
Lost:
Motion Alert is sent when motion is detected.
Detected:
Passive Alert is sent when passive infrared sensor is triggered.
Infrared:
Digital
Alert is sent when the signal voltage is above or below a specific
Input:
threshold.
Sound
Alert is sent when a sound is detected. Applies only to cameras which
Detection:
have audio recording enabled.
Hard Disk
When the Overwrite function is not enabled, the NVR will stop recording
Space Full:
when the HDD is full and will send an alert.
Hard Disk
An alert will be sent if there is an error with the hard disk.
Error:
Fan Error:
An alert will be sent if there is a fan error.
Network An alert will be sent if the network connection is lost.
Disconnected:
D-Link DNR-322L User Manual

Event Settings

48