4.5 Process Group Configuration
Note. The number of Process Groups and associated channel options displayed depend on the
number of Process Groups selected during common configuration setup – see Section 4.4.1.
4.5.1 Setting the Recording Parameters
Process Group 1
or
Process Group 2
or
Process Group 3
(see Note below)
Fig. 4.11 Selecting Process Group Configuration
Enter the process group tag (maximum 20 characters) that
appears in the title bar when any operator views from that
group are displayed.
Note. Each process group tag
Select a signal source to enable/disable recording of all
channels in the current Process Group. Refer to APPENDIX 1
for a description of the available sources.
Note. This signal is edge-triggered. A rising edge (inactive to
active) enables recording. A falling edge (active to inactive)
disables recording.
Enabled
Disabled
4 CONFIGURATION...
be unique.
must
69