Table of Contents
Advertisement
Removing the FBWC capacitor pack holder
WARNING:
remove the power cord to remove power from the server. The front panel Power On/Standby
button does not completely shut off system power. Portions of the power supply and some internal
circuitry remain active until AC power is removed.
To remove the component:
CAUTION:
Do not use the controller with cache modules designed for other controller models, because the
controller can malfunction and you can lose data. Also, do not transfer this cache module to an
unsupported controller model, because you can lose data.
Back up all data.
1.
Close all applications.
2.
Power down the server (on page 25).
3.
Remove all power:
4.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
CAUTION:
powered down and the last to be powered back up. Taking this precaution ensures that the system
does not erroneously mark the drives as failed when the server is powered up.
Extend the server from the rack (on page 25).
5.
Remove the access panel (on page 29).
6.
Extend the processor memory drawer approximately 2.54-5.1 cm (1-2 inches).
7.
Remove any capacitor packs installed in the holder
8.
To reduce the risk of personal injury, electric shock, or damage to the equipment,
The cache module connector does not use the industry-standard DDR3 mini-DIMMs.
In systems that use external data storage, be sure that the server is the first unit to be
("Removing the capacitor
Removal and replacement procedures 48
pack" on page 45).
Advertisement
Table of Contents
