Table of Contents
Advertisement
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend the server from the rack (on page 25).
3.
Remove the access panel (on page 29).
4.
Remove the processor memory drawer shipping screws, if installed. Retain the screws for future use
5.
("Processor memory drawer shipping screw
Extend the processor memory drawer approximately 2.54-5.1 cm (1-2 inches).
6.
Loosen the thumbscrews on the SPI board, and then lift the SPI board to access the cables.
7.
Disconnect all cables from the SPI board.
8.
IMPORTANT:
number through the Advanced System ROM options in UEFI System Utilities
server serial number and product
Remove the SPI board from the server.
9.
If replacing the SPI board or clearing NVRAM, you must re-enter the server serial
ID" on page 70).
locations" on page 30).
Removal and replacement procedures 32
("Re-entering the
Advertisement
Table of Contents
