Important Instructions; Tools Required - Cadet COM-PAK Owner's Manual

IMPORTANT INSTRUCTIONS

When using electrical appliances, basic precautions should always be
followed to reduce the risk of fire, electric shock, and injury to persons,
including the following:
1. Read all instructions before using
this heater.
2. This heater is hot when in use.
To avoid burns, do not let bare skin
touch hot surfaces. Keep combusti-
ble materials, such as furniture, pil-
lows, bedding, papers, clothes, etc.
and curtains at least 3 feet (0.9 me-
ters) from the front of the heater and
keep them away from the sides and
rear.
3. Extreme caution is necessary
when any heater is used by or near
children or invalids and whenever
the heater is left operating and
unattended.
4. Do not operate any heater after
it malfunctions. Disconnect power
at service panel and have heater
inspected by a reputable electrician
before reusing.
5. Do not use outdoors.
SAVE THESE INSTRUCTIONS
Wire Strippers
Drill and Drill Bits
Volt Meter
A multi-purpose tool or something to cut your existing drywall or gypsum board.

TOOLS REQUIRED

Wire Connectors
2
6. To disconnect heater, turn con-
trol(s) to off, and turn off power to
heater circuit at main disconnect
panel.
7. Do not insert or allow foreign ob-
jects to enter any ventilation or ex-
haust opening as this may cause an
electric shock or fire, or damage the
heater.
8. To prevent a possible fire, do not
block air intakes or exhaust in any
manner.
9. A heater has hot and arcing or
sparking parts inside. Do not use it in
areas where gasoline, paint, or flam-
mable vapors or liquids are used or
stored.
10. Use this heater only as described
in this manual. Any other use not rec-
ommended by the manufacturer may
cause fire, electric shock, or injury to
persons.
1½" Wood Screws
Tape Measure
Hammer
Straight and Phillips
Screwdrivers
½" Cable Clamp
Connector
Stud Finder