Cadet 10F2500 Owner's Manual

Electric Baseboard
Features & Benefits
Oversized high temperature limit switch with full
•
length sensor for added safety
Durable steel sheathed element with a limited
•
lifetime warranty
Easy installation with pre-punched case at 1" intervals
•
Rugged steel construction
•
Thermostat not included
•
WARNING!
Turn the electrical power off at the electrical
panel board (circuit breaker or fuse box) and
lock or tag the panel board door to prevent
someone from turning on power while you are
working on the heater. Failure to do so could
result in serious electrical shock, burns, or
possible death.
CAUTION - High Temperature. Keep electrical cords, drapes, and
other furnishings away from heater.
When using electrical appliances, basic precautions should
always be followed to reduce the risk of fire, electric shock, and
injury to persons, including the following:
1. Read all instructions before using this heater.
2. Read all information labels. Verify that the electrical supply
wires are the same voltage as the heater.
3. All electrical work and materials must comply with the
National Electric Code (NEC), the Occupational Safety and
Health Act (OSHA), and all state and local codes.
4. The heater must be grounded to one of the grounding screws
provided.
5. If you need to install a new circuit or need additional wiring
information, consult a qualified electrician.
6. Protect electrical supply from kinks, sharp objects, oil, grease,
hot surfaces or chemicals.
7. Do not place heater against paperboard or low-density
cellulose fiberboard surfaces.
8. Do not place heater below an electrical convenience receptacle.
www.cadetco.com
The Cadet
OWNER'S GUIDE
IMPORTANT INSTRUCTIONS
SAVE THESE INSTRUCTIONS
Tel: 360-693-2505
240/208 VOLT MODELS
2F350
2F500
3F750
4F1000
5F1250
208 VOLT MODELS
2F500-8
5F1250-8
8F2500-8
120 VOLT MODELS
2F500-1
6F1500-1
TOOLS REQUIRED
Phillips
•
Screwdriver
Straight
•
Screwdriver
Wire Strippers
•
Drill or Hammer
•
9. WARNING
Overheating or fire may occur. Do not install the heater behind
doors.
10. WARNING
Fire or explosion may occur. Heater has hot and arcing or
sparking parts inside. Do not install heater in any area where
combustible vapors, gases, liquids, or excessive lint or dust
are present.
11. WARNING
Burn Hazard. This heater is hot when in use. To avoid burns,
do not let bare skin touch hot surfaces. Use extreme caution
when any heater is used by or near children or invalids and
whenever the heater is left operating unattended. Keep
combustible materials, such as furniture, pillows, bedding,
papers, clothes, and curtains away from heater.
12. WARNING
Risk of electrical shock. Do not insert or allow foreign objects
to enter any ventilation or exhaust opening as this may cause
an electric shock or fire, or damage the heater.
13. WARNING
Risk of Fire. Do not block heater. To prevent a possible fire, do
not block air intakes or exhaust in any manner. Heater must be
kept clear of all obstructions: minimum of 12 inches in front
and above, 6 inches on both sides. Heater must be kept clean
of excessive lint, dirt and debris (See Maintenance Instructions).
14.Use this heater only as described in this manual. Any other use
not recommended by the manufacturer may cause fire,
electrical shock, or injury to persons.
P.O. Box 1675 Vancouver, WA 98668-1675
6F1500
8F2000
8F2500
8F2025
10F2500
3F750-8 4F1000-8
6F1500-8 8F2000-8
3F750-1 4F1000-1
Drill Bits
•
(4) Wood Screws
•
Wire Connectors
•
(1) Strain Relief
•
Connector
1