Table of Contents
Advertisement
Security
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Main
Advanced
Chipset
Boot
Security
Password Description
If ONLY the Administrator's password is set,
then this only limits access to Setup and is only
asked for when entering Setup.
If ONLY the User's password is set, then this
is a power on password and must be entered to
boot or enter Setup. In Setup the User will have
Administrator rights.
The password length must be
in the following range:
Minimum length
3
Maximum length
20
Administrator Password
User Password
UEFI Secure Boot Management
Secure Boot Control
[Disabled]
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Administrator Password
Set the administrator password.
User Password
Set the user password.
Secure Boot Control
The secure boot is possible only when the system runs under the user mode.
Chapter 3 BIOS Setup
Chapter 3
Save & Exit
Set Administrator
Password.
Select Screen
Select Item
Enter: Select
+/ -:
Change Opt.
F1:
General Help
F2:
Previous Values
F3:
Optimized Defaults
F4:
Save & Reset
ESC: Exit
Save & Exit
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Main
Advanced
Chipset
Boot
Save Changes and Reset
Discard Changes and Reset
Save Opions
Save Changes
Discard Changes
Restore Defaults
Save as User Defaults
Restore User Defaults
Boot Override
Launch EFI Shell from fi lesystem device
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Save Changes and Reset
To save the changes, select this field and then press <Enter>. A dialog box will appear.
Select Yes to reset the system after saving all changes made.
Discard Changes and Reset
To discard the changes, select this field and then press <Enter>. A dialog box will ap-
pear. Select Yes to reset the system setup without saving any changes.
Save Changes
Save changes done so far to any of the setup options.
Discard Changes
Discard changes done so far to any of the setup options.
Restore Defaults
To restore and load the optimized default values, select this field and then press <En-
ter>. A dialog box will appear. Select Yes to restore the default values of all the setup
options.
Save as User Defaults
To save changes done so far as user default, select this field and then press <Enter>.
A dialog box will appear. Select Yes to save values as user default.
47
Security
Save & Exit
Reset the system after
saving the changes.
Select Screen
Select Item
Enter: Select
+/ -:
Change Opt.
F1:
General Help
F2:
Previous Values
F3:
Optimized Defaults
F4:
Save & Reset
ESC: Exit
Advertisement
Table of Contents
Troubleshooting
