3.3.10 EZJ114 board (LED / SW board)
[Function]
- LED display of Power, Ready, Fault, Warning, and Start / Stop switch
[Notes in case of the board replacement]
- Before replacing the board, be sure to turn off the power.
- After replacing the board, be sure to joint connectors to right places.
[EZJ114 board external view]
CN2:
(Connection to
EZJ126 board)
CN3:
(Connection to
EZJ128 board)
CN4:
3.3.11 EZJ119A board (Relay output board) (Optional board)
[Function]
- Relay output (Ready, Fault, Warning) for conveyer.
[Notes in case of the board replacement]
- Before replacing the board, be sure to turn off the power.
- Before replacing the board, be sure not to supply the electric power to the wires
connecting to TB2.
[EZJ119A board external view]
Two fixing screws
(M3)
SW3:
Ready output
selector switch
[ Replacement procedure of EZJ119A board ]
(1) Turn off the power and open the top cover.
(2) Remove the connectors (CN7) of EZJ119A board.
(3) Remove the two fixing screws.
(4) Install a new EZJ119A board by reversing the above procedure.
Two fixing screws
(M3)
USB connector
Terminal block:
(TB2: M4)
3-30
CN1:
SW1
SW2
(Connection to
(Start)
(Stop)
EZJ113 board)
Note) These parts are not mounted
on EZJ114B board for RX2-B
Two fixing screws
(M3)
CN7:
(Connection to
EZJ126 board)