Huawei AR1200-S Configuration Manual page 135

Huawei AR1200-S Series Enterprise Routers
Configuration Guide - Security
Step 5 Configure MAC address bypass authentication.
[Huawei] interface ethernet 2/0/1
[Huawei-Ethernet2/0/1] dot1x mac-bypass
Step 6 Verify the configuration.
Run the display dot1x interface command on the Router to view the 802.1x authentication
configuration and statistics.
<Huawei> display dot1x interface ethernet 0/0/0
Ethernet0/0/0 status: UP
Port control type is auto.
Authentication method is MAC-based.
Reauthentication is disabled.
Maximum users: 128
Current users: 1
Port PVID : 1
Port configured PVID : 1
Guest VLAN : 10
Restrict VLAN : 0
Authentication success: 4
Authentication failure: 0
EAPOL Packets: TX
Sent
Received
<Huawei> display dot1x interface ethernet 2/0/1
Ethernet 2/0/1 status: UP
Port control type is Auto.
Authentication method is MAC-based.
Reauthentication is disabled.
Maximum users: 128
Current users: 1
Port PVID : 1
Port configured PVID : 1
Guest VLAN : 0
Restrict VLAN : 0
Authentication success: 4
Authentication failure: 0
EAPOL Packets: TX
Sent
Received
----End
Configuration Files
#
vlan batch 10 20
#
dot1x enable
#
Issue 02 (2012-03-30)
802.1x protocol is enabled.
: 10
EAPOL Request/Identity Packets
EAPOL Request/Challenge Packets : 4
Multicast Trigger Packets
EAPOL Success Packets
EAPOL Failure Packets
EAPOL Start Packets
EAPOL LogOff Packets
EAPOL Response/Identity Packets : 4
EAPOL Response/Challenge Packets: 4
802.1x protocol is Enabled[mac-bypass]
: 10
EAPOL Request/Identity Packets
EAPOL Request/Challenge Packets : 4
Multicast Trigger Packets
EAPOL Success Packets
EAPOL Failure Packets
EAPOL Start Packets
EAPOL LogOff Packets
EAPOL Response/Identity Packets : 4
EAPOL Response/Challenge Packets: 4
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
RX : 0
: 4
: 0
: 4
: 0
: 4
: 3
RX : 0
: 4
: 0
: 4
: 0
: 4
: 3
5 NAC Configuration
121