Philips WP3811 User Manual page 9

 Place the matching adapter (A-type) over the tip of the spout. The
16mm adapter is packed with the water purifier. Replace it with
the 17.5mm adapter or 19mm adapter to fit the diameter of your
tap (Fig. 5).
 Screw the attachment nut firmly onto the water purifier
housing (Fig. 6).
installation B-type adapter
- For taps with an aerator (threaded outside) (Fig. 7).
1 Remove the attachment nut and the adapter from the water
purifier (Fig. 8).
 Remove the aerator cap from the tap and pass the attachment nut
over the spout. Take out the original adapter and screw the
matching adapter (B-type) onto the tap (Fig. 9).
 Tighten the adapter further with a coin (Fig. 10).
 Firmly screw the attachment nut onto the water purifier
housing (Fig. 11).
installation C-type adapter
- For taps with an aerator (threaded inside) (Fig. 12).
1 Remove the attachment nut and the adapter from the water
purifier housing (Fig. 13).
 Remove the aerator cap from the tap. Take out the original adapter
and screw the matching adapter (C-type) onto the tap through the
attachment nut. (Fig. 14)
 Tighten the adapter further with a coin (Fig. 15).
 Firmly screw the attachment nut onto the water purifier
housing (Fig. 16).
installation D-type adapter
- For taps other than A, B or C. (Fig. 17)
1 Remove the attachment nut and the adapter from the water
purifier housing (Fig. 18).
English
9