Philips WP3811 User Manual page 8

English
8
- Apart from the recommended cartridge lifetime, Philips' unique
cartridge replacement indicator helps you determine when to replace
the filter cartridge.
- The 2ltrs/min high-speed initial flow rate gives you a plenty of clean
water instantly.
- The water selection lever offers you a choice of three water flow
types: unfiltered spray, unfiltered stream or filtered spray.
- The eight tap-mounting adapters supplied with the water purifier
allow easy installation on almost any type of tap.
- The bayonet-type mount ensures quick, easy and secure filter
cartridge replacement.
Preparing for use
Before installation
- Before you install the water purifier, make sure all tap-mounting
adapters you require are present.
- The tap must have a diameter of 13mm-25mm.
- Determine what type of tap you have and select the appropriate
adapter.
- The adapters supplied make the water purifier suitable for almost
any kitchen tap. However, the water purifier may not fit some
uncommon types of taps.
- The tap water pressure has to be between 0.7kgf/cm² (7 metres of
water column) and 3.5kgf/cm² (35 metres of water column). If you
use the water purifier at a water pressure outside this range, either
the filtered water flow will be extremely low or the water purifier
will get damaged.
installation a-type adapter
- For taps with a round spout with a diameter of 16mm, 17.5mm or
19mm (Fig. 2).
1 Remove the attachment nut and the adapter from the water
purifier housing (Fig. 3).
 Pass the attachment nut over the tap spout (Fig. 4).