Philips WP3811 User Manual page 10

English
10
 Take out the original adapter and screw the D-type adapter onto
the water purifier housing. (Fig. 19)
 Push the water purifier housing onto the tap from below and
tighten the 4 screws evenly (Fig. 20).
 Screw the attachment nut firmly onto the water purifier
housing (Fig. 21).
Make sure the rubber washer is firmly pushed against the tap to prevent
water leakage.
installing the filter cartridge
1 Make sure the tap is closed.
 Set the water selection lever to the unfiltered stream
position (Fig. 22).
 Tilt the filter cartridge 90° backwards and insert it into the water
purifier housing. (Fig. 23)
 Pull the cartridge upwards until it is in upright position. (Fig. 24)
using the appliance
1 Make sure that the water purifier housing and the filter cartridge
are properly installed.
 Turn the water selection lever to the desired setting ('click').
Filtered spray
Select this setting for drinking, washing vegetables or fruits and
for cooking.
1 Turn the water selection lever until the filtered spray symbol is
aligned with the indicator (Fig. 25).
Do not let water hotter than 50°C run through the water purifier at
this setting, as this may damage the water purifier.