Table of Contents
Advertisement
This chapter describes the RCM3000 hardware in more detail, and
explains how to set up and use the accompanying Prototyping Board.
NOTE: This chapter (and this manual) assume that you have the RCM3000 Development
Kit. If you purchased an RCM3000 module by itself, you will have to adapt the infor-
mation in this chapter and elsewhere to your test and development setup.
2.1 Development Kit Contents
The RCM3000 Development Kit contains the following items:
• RCM3010 module with Ethernet port, 256K flash memory, and 128K SRAM.
• RCM3000 Prototyping Board.
• AC adapter, 9 V DC, 1 A. (Included only with Development Kits sold for the North
American market. A header plug leading to bare leads is provided to allow overseas
users to connect a power supply compatible with their local mains power.)
• 10-pin header to DE9 programming cable with integrated level-matching circuitry.
• Dynamic C SE CD-ROM, with complete product documentation on disk.
• This Getting Started manual.
• A bag of accessory parts for use on the Prototyping Board.
• Registration card.
Getting Started
2. H
ARDWARE
S
ETUP
7
Advertisement
Table of Contents
Need help?
Do you have a question about the RCM3000 and is the answer not in the manual?
Questions and answers