Table of Contents
Advertisement
ATTENTION!
Measuring directly on the line voltage can be very dangerous.
The outside of the BNC connectors at the Handyscope HS3 are
connected with the ground of the computer. Use a good isolation
transformer or a differential probe when measuring at the line volt-
age or at grounded power supplies! A short-circuit current will
flow if the ground of the Handyscope HS3 is connected to a positive
voltage. This short-circuit current can damage both the Handyscope
HS3 and the computer.
Copyright c 2016 TiePie engineering.
All rights reserved.
Revision 2.16, June 2016
Despite the care taken for the compilation of this
user manual, TiePie engineering can not be held
responsible for any damage resulting from errors
that may appear in this manual.
Advertisement
Table of Contents
Need help?
Do you have a question about the Handyscope HS3 and is the answer not in the manual?