Table of Contents
Advertisement
When the instrument is still connected, the driver install utility
will recognize it and report this. You will be asked to continue
anyway.
Figure 4.3: Driver install: Instrument is still connected
Clicking No will bring back the previous screen. The instru-
ment should now be disconnected. Then the removal of the existing
driver can be continued by clicking Next .
Clicking Yes will ignore the fact that the instrument is still
connected and continue removal of the old driver. This option is
not recommended, as removal may fail, after which installation of
the new driver may fail as well.
When no existing driver was found or the existing driver is
removed, the location for the pre-installation of the new driver can
be selected.
Figure 4.2: Driver install: step 2
Driver installation
15
Advertisement
Table of Contents
Need help?
Do you have a question about the Handyscope HS3 and is the answer not in the manual?