Advertisement
54
2 brass tubes, 6.4 Ø x 1000
55
8 clevises, M3
56
5 clevises, M2.5
56a
2 self-locking nuts, M6
57
3 ball-links, M2.5
58
8 locknuts, M3
59
9 locknuts, M2.5
60
3 ball-links
61
3 self-locking nuts, M2
62
2 sheet metal servo mounts
63
6 self-tapping screws, M2.6 x 6.5
64
4 socket-head cap screws, M3 x 10
65
4 self-locking nuts, M3
66
4 washers, 6 Ø x 3.2
67
CFRP rod, 5 Ø x 1000
68
4 captive nuts, M3
69
Cyano-acrylate adhesive
70
UHU plus endfest 300
71
Soft binding wire
72
Decal sheet
HARPOON II
Supplementary Building Instructions - Harpoon 2
Important note:
The building instructions for the Harpoon 2 are based on the earlier instructions supplied with the
previous version of the model, which means that the second section - the Appendix - only covers important
changes and new procedures. Most of the difficult stages have been completed by the manufacturer, but in
any case they are also covered by the Harpoon 1 instructions. The expanded building instructions also
describe and illustrate virtually every stage of building. In most cases you will find that the photos are
easier to understand than complex text instructions. Before you start building the model it is essential to
read right through the instructions, from start to finish, and to study the illustrated procedures.
The construction of this model requires a high level of technical knowledge, manual skill and piloting
experience. Operating a model with a jet engine calls for a highly circumspect approach and specialised
technical expertise. Please read and observe the Safety Notes in the Operating Instructions.
RC functions
Turbine power (throttle stick)
Nosewheel steering (coupled to rudder using Magic-Box, Order No. 3162, or Y-lead)
Elevons (combined ailerons / elevators); four servos: two per wing panel, coupled using Magic-Boxes, No. 3162
Rudder; two servos (1 servo per rudder, coupled to nosewheel using Magic-Box, Order No. 3162, or Y-lead)
Retractable undercarriage
Wheelbrakes
Optional speedbrake (airbrake)
Canards
Thrust vectoring pipe
Recommended radio control systems
GRAUPNER/JR mc-20, mc-22, mc-24 or mx-22 35 MHz computer system. This applies to Germany; you may
have to use a different frequency band for your country.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler! Ident-Nr. 0057999
04/2003
71
71
Wing incidence pegs
Aileron linkage
Rudder / Vector /
Speedbrake linkage
Securing part 13
Aileron pushrods
Rudder / Vector linkage
Rudder / Vector pipe
Securing part 60
Thrust vector servo
Securing part 62
Vector servo
Part 64
Part 64
Fueltank supports
Turbine mounting
Made in Thailand
Advertisement
