Connecting External Accessories; Power Supply; Serial Communications; Developer Board Power Switch And Adapter Connector (Rear) - Motorola G30 Technical Information

Initial Setup

Connecting External Accessories

Replace the Developer Board cover and connect the following external connectors in the
sequence shown.

Power Supply

Caution:
Caution:
To Connect the Power Supply
1. Connect the supplied Wall adapter to the Wall Adapter Connector (J230)
The Wall Adapter Connector is located to the left of the Developer Board On/Off switch
(labeled Power ) at the rear of the Developer Board.
2. Plug the adapter into a wall outlet.
Note:
Wall-mount
Adapter Connector
Figure 2-5: Developer Board Power Switch and Adapter Connector (Rear)

Serial Communications

RS232 serial interface is available for communicating with a PC. The G30 Developer's Kit
includes the necessary RS232 cable for connecting to a PC.
To Connect Serial Communication Cables
•
Connect
RS232-1 connector (J300), or to the RS232-2 connector (J330) for data logging.
12
Before connecting the power supply, make sure that the Developer Board On/Off
switch (located in the rear of the board, as shown in
position.
When using the Wall adapter, make sure to insert it into the Power Adapter
Connector (J210) and not to the Mini-AB USB connector (J380), as shown in
Figure 2-5.
The G30 Developer Board can also be powered by an external DC power supply. This
option is described in "Configuration" on page
Power
Indicator LED
Developer Board
On/Off Switch
(Figure 2-5) either the supplied RS232 cable with a male D-type connector to
G30 Developer's Kit
Figure 2-5) is in the OFF
(Figure
16.
December 15, 2009
2-5).