Wall Mount Adapter Operation; G30 Developer's Kit Wall Mount Adapter Connector; Wall Mount Adapter Connector Pinout (J210) - Motorola G30 Technical Information

Wall Mount Adapter Operation

To Use a Wall Mount Adapter
1. Connect the Wall mount adapter to the Power Adapter connector (J210)
2. Verify that jumper P203 is connected and jumper P204 is disconnected (default setup).
Important:
Wall-mount
Adapter Connector
Figure 2-10: G30 Developer's Kit Wall Mount Adapter Connector
The Wall Mount Adapter connector is located at the rear of the Developer Board,
immediately to the left of the Power On/Off switch.
The Wall Mount Adapter connector pinout is described in
constant 4.5 V, which is regulated to a nominal 4.1 V on the Developer Board.
Important:
December 15, 2009
Chapter 2: Developer Board and Interfaces Description
Verify that the Wall mount adapter is not connected to the USB connector (J380).
Power
Indicator LED
Power
On/Off Switch
Table 2-1: Wall Mount Adapter Connector Pinout (J210)
Pin #
1
2
3
5
6
The G30 includes an on-board protection circuit for cases in which the USB
connector is connected by mistake to the Wall Mount Adapter connector (J210).
If by mistake, the Mini AB USB cable is connected to J210 instead of J380, the on
board Wall mount adapter is disabled, preventing unrequired load on the host
computer.
G30 Developer's Kit
Table 2-1. The adapter supplies a
Pin Name
GND
Not connected
Not connected
Detection circuit
VCC
(Figure 2-10)
17