Initial Setup; Connecting The G30 Adapter - Motorola G30 Technical Information

Initial Setup

This section describes the initial procedure for setting up the Developer Board for G30 testing
and evaluation. The tasks in this section need to be performed only once, prior to initial use of the
Developer's Kit. After performing the initial setup, you can modify the default settings or use
different peripheral devices, as described in
Perform the steps in this section in sequence.
Before starting, remove the cover of the Developer Board. The cover simply slides up off the
board, and does not require the removal of any screws or clips. After setting up the Developer
Board, replace the cover simply by pushing it gently back into place. Make sure the cover is
aligned properly with the external connectors on the side of the board.
Note:

Connecting the G30 Adapter

To Connect the G30 Adapter to the Developer Board
1. Place the G30 adapter
rectangle, and push the G30 adapter 70-pin connector down into the G30 70-pin connector
on the Developer Board.
The screw hole on the G30 adapter should be aligned with the G30 spacer (denoted by M2).
2. Fasten the G30 adapter to the Developer Board using one M2 screw provided with the kit.
3. Connect the internal RF cable MMCX connector to the MMCX connector of the G30
adapter by pushing it in until it clicks
4. Insert the External Antenna Connector into the dedicated hole in the Developer Board cover
and close nut.
5. Connect the external RF cable between the External Antenna Connector and the Internal
Antenna Connector
This connects the G30 adapter to the antenna.
December 15, 2009
Numbers that appear in parentheses throughout the following paragraphs (Jxxx, Sxxx,
etc.), refer to components reference designation numbers as they are given on the
developer board and in the schematic diagrams.
(Figure 2-2) on the Developer Board area, marked by a white
(Figure 2-2).
G30 Developer's Kit
Chapter 2: Developer Board and Interfaces Description
"Configuration" on page
(Figure 2-2).
16.
9