Mighty Mule MM660 Installation Manual page 33

Hide thumbs

Table Of Contents

Table of Contents

Setting Personal Transmitter Code

AUTO CLOSE TIME

OFF

SOFT START OFF

WARNING

OPEN

SLV OPEN

MODE1

MODE2

Release the remote button, then release the "LEARN RMT" but-

ton. The new code is now programmed.

WARNING: Changes, modifications or adjustments not expressly approved by GTO Access Systems, LLC could void the user's authority to

operate this equipment. There Are No User Serviceable Parts.

NOTICE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 the FCC. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

STALL FORCE

STATUS

LEARN RMT

120

MIN

MAX

OFF

LEARN

PULL

PUSH

MAST LIMIT