TP-Link m7310 User Manual page 28


Mobile Data: It is enabled by default. You can disable it to prohibit Internet access.

Data Roaming: It is disabled by default. If disabled, data service is not allowed when
roaming.

Profile List: A list of profile for you to select. If you find any parameters wrong, you can
click Create to create a new profile with the right settings (as shown in the next figure).
Select a profile you have created, you can further modify its parameters.

Profile Name: The name of the profile you've selected.

PDP Type: Select the type of your PDP (Packet Data Protocol).

APN Type: Select the type of your APN, either Dynamic or Static. If you select Dynamic,
the Mobile Wi-Fi will have dynamic APN, which does not need to be specified. If you select
Static, you can manually specify your APN.

APN: Access Point Name, provided by your ISP. You need to set APN only after selecting
the static APN type. You are recommended to keep the default value.

Auth Type: Some ISPs need a specific authentication type, please confirm it with your ISP
or keep the default value.

None: No any authentication is needed.

PAP: Password Authentication Protocol. This protocol allows the Mobile Wi-Fi to
establish authentication with the peer using two handshakes. Select this option if the
ISP requires this authentication type.

CHAP: Challenge Handshake Authentication Protocol. This protocol allows the Mobile
Wi-Fi to establish authentication with the peer using three handshakes and checking
M7310 LTE-Advanced Mobile Wi-Fi User Guide
-21-