Error Code Indication - Bosch Nyon 1 270 020 907 Original Instructions Manual

OBJ_BUCH-2616-002.book Page 10 Thursday, May 12, 2016 12:37 PM
English–10

Error Code Indication

The components of the eBike system are continuously and au-
tomatically monitored. If an error is detected, the respective
error code is indicated on the on-board computer.
Depending on the type of error, the drive unit is automatically
shut off, if required. Continued travel without assistance from
Code Cause
410 One or more buttons of the on-board
computer are blocked.
414 Connection problem of the operating
unit
418 One or more buttons of the operating
unit are blocked.
419 Configuration error
422 Connection problem of the drive unit Have connections and contacts checked.
423 Connection problem of the eBike bat-
tery pack
424 Communication error among the com-
ponents
426 Internal time-out error
430 Internal battery pack of the on-board
computer is empty.
431 Software version error
440 Internal error of the drive unit
450 Internal software error
460 Error at USB connection
490 Internal error of the on-board com-
puter
500 Internal error of the drive unit
502 Bike lighting error
503 Error of the speed sensor
510 Internal sensor error
511 Internal error of the drive unit
530 Battery pack error
1 270 020 XBN | (12.5.16)
the drive unit is possible at any time. However, have the eBike
checked before attempting new trips.
 Have all repairs performed only by an authorised bike
dealer.
Corrective Measure
Check if any buttons are blocked, e.g. from dirt or debris. Clean the but-
tons, if required.
Have connections and contacts checked.
Check if any buttons are blocked, e.g. from dirt or debris. Clean the but-
tons, if required.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Have connections and contacts checked.
Have connections and contacts checked.
Restart the system. If the problem persists, contact your Bosch eBike
dealer. In this error status, it is not possible to display or adjust the wheel
circumference in the basic settings menu.
Charge the on-board computer (in the holder or via the USB port).
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Remove the cable from the USB connection of the on-board computer.
If the problem persists, contact your Bosch eBike dealer.
Have the on-board computer checked.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Check the light and the associated wiring. Restart the system. If the prob-
lem persists, contact your Bosch eBike dealer.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Switch off the eBike, remove the eBike battery pack and reinsert the
eBike battery pack. Restart the system. If the problem persists, contact
your Bosch eBike dealer.
Bosch eBike Systems