Error Code Indication - Bosch Performance Line 0 275 007 031 Original Instructions Manual

English–9

Error Code Indication

The components of the eBike system are continuously and au-
tomatically monitored. If an error is detected, the respective
error code is indicated on the on-board computer.
Depending on the type of error, the drive unit is automatically
shut off, if required. Continued travel without assistance from
Code Cause
410 One or more buttons of the on-board
computer are blocked.
414 Connection problem of the operating
unit
418 One or more buttons of the operating
unit are blocked.
422 Connection problem of the drive unit
423 Connection problem of the eBike
battery pack
424 Communication error among the
components
426 Internal time-out error
430 Internal battery pack of the on-board
computer is empty
440 Internal error of the drive unit
450 Internal software error
490 Internal error of the on-board computer Have the on-board computer checked
500 Internal error of the drive unit
502 Bike lighting error
Error of the speed sensor
503
510 Internal sensor error
511 Internal error of the drive unit
530 Battery pack error
531 Configuration error
540 Temperature error
550 An improper load was detected.
0 276 001 SPN | (17.7.14)
the drive unit is possible at any time. However, have the eBike
checked before attempting new trips.
 Trouble-shooting actions may be performed by the
owner except those explicitly noted as "Contact your
Bosch eBike dealer".
Corrective Measure
Check if any buttons are blocked, e.g. from dirt or debris. Clean the
buttons, if required.
Have connections and contacts checked.. Contact your Bosch eBike
dealer.
Check if any buttons are blocked, e.g. from dirt or debris. Clean the
buttons, if required.
Have connections and contacts checked.
Have connections and contacts checked.
Have connections and contacts checked.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Charge the on-board computer (in the holder or via the USB port)
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Check the light and the associated wiring. Restart the system. If the prob-
lem persists, contact your Bosch eBike dealer.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
Switch off the eBike, remove the eBike battery pack and reinsert the
eBike battery pack. Restart the system. If the problem persists, contact
your Bosch eBike dealer.
Restart the system. If the problem persists, contact your Bosch eBike
dealer.
The eBike is outside of the permissible temperature range. Switch off the
eBike system and allow the drive unit to either cool down or heat up to the
permissible temperature. Restart the system. If the problem persists,
contact your Bosch eBike dealer.
Remove load. Restart the system. If the problem persists, contact your
Bosch eBike dealer.
Bosch eBike Systems