Oki B721 User Manual page 65

13
When WEP is selected:
-(1)
a) Press the <ENTER> button on the WEP Key
input screen.
Note
● There is not setting for the WEP Key index. The WEP
Key index communications with the access point as
1.
b) Enter the same Key as the WEP Key set for the
access point that you want to connect to.
Memo
● After entering the Key, the key is displayed as "*"
symbols for security reasons.
13
When WPA-PSK or WPA2-PSK is
-(2)
selected:
a) Press the <ENTER> button to select WPA
Encryption Type and then press the <ENTER>
button.
Memo
● The default is [TKIP].
● If the encryption scheme for the access point of the
Wireless LAN is WPA-PSK, select THIP. If it is WPA2-
PSK, select AES.
b) Press the <ENTER> button on WPA Pre-
shared key input screen.
Note
● Characters are case sensitive. Enter them correctly.
c) Enter the same Key as the Pre-shared Key set
for the access point that you want to connect
to.
Memo
● After entering the Key, the key is displayed as "*"
symbols for security reasons.
14
In the confirmation screen, check the
entered SSID and selected security
settings.
If there are no problems, press the scroll button
to select [Yes] and then press the <ENTER>
button.
15
[Searching for connection] is
displayed on the screen.
When [Connection successful] is displayed, this
equipment is connected to the wireless LAN.
Memo
● If [Timeout] is displayed, the connection destination
access point may not have been found within the
specified time. Check that SSID, security settings,
and Key settings, and retry.
- 65 -
Connecting to a Computer
3