Disassembly And Reassembly Of Door; Replacing Broken Glass; Replacing Glass Fiber Rope - J. A. Roby CUISINIERE Instruction Manual

Disassembly and reassembly of door

Do not unscrew the lower hinge when disassemble the door.
1) Keep the door locked.
2) Loosen the upper hinge without removing the nut.
3) Unlock the door and open it while holding it.
4) Tilt the door slowly downward to remove the upper
hinge
5) Lift the door and remove the lower hinge.
Installing the door
1) Insert the bottom hinge and bring up the door. Place
the nail in the upper hinge.
2) Close and lock the door, then make sure the door is
placed horizontally.
3) Tighten the upper hinge and align the washer with the
hinge support.
4) Carry out the air tighten adjustment.

Replacing broken glass


Do not hit the glass to avoid breaking it.

Do not pour water. It might cause thermal shock.

Do not slam the door.

Do not build fire too close the door.
WARNING: NEVER USE THE STOVE WHEN THE GLASS IS
BROKEN OR CRACKED.
Replace only with a 4 mm ceramic glass with the right shape.
Contact your retailer to get the replacement glass panel.
DO NOT USE SUBTITUTE
How to replace the glass
1) Loosen partially the screws retaining the four glass
supports.
2) Remove the broken pieces of glass and clean the
door.
3) There must be a flat glass fibre rope for airtightness
around the glass. You have to install new one in case
of loss or damage. The flat glass fiber rope is self-
adhesive. Stick it around the glass without pressing it
excessively.
4) Install the new glass panel and replace the lower
support first and gently tighten screw. If you tighten it
too much, it might make a pressure point and break
the glass when it becomes hot. Then press gently the
glass fibre rope against the door.
5) Install the upper support and tighten the screws gently
but not too tight.
6) Check all the screws.
If it is impossible to replace the glass in vertical position, you
may have to remove the door. Refer to the section concerned
in this manual.

Replacing glass fiber rope

When the braided glass fibre rope is all flattened out, it
becomes impossible to close the door hermetically. This
means that the glass fibre rope is no longer usable or that the
rope is damaged. You must therefore replace it.
November 5, 2015
Use a ½ inch (12.7mm) braided glass fiber rope.
It is preferable to detach the door from the stove when you
replace the rope. Refer to the section concerned in this
manual.
Glass fiber rope preparation
1) Take the end of the glass fiber rope and tuck fiber
inside to make a clean end.
2) Put little amount of high temperature sealant, such as
latex or silicone, at the end of the fiber glass rope so
that it won't come loose.
3) Remove old glass fiber rope from the door and clean
the groove.
4) Starting from the lower corner near the hinge, put the
glass fiber rope into the groove without giving any
tension. Verify the length of rope.
5) Cut it ½ inches over the require length and repeat
step 1 and 2.
Glass fiber rope installation
1) Put a high temperature sealant in the clean groove to
glue the glass fiber rope.
2) Place glass fiber rope into the groove starting from the
lower corner near the hinge without giving any tension
3) Glue the two glass fiber rope ends with high-
temperature sealant to make a right angle.
4) Let dry the sealant for at least 48 hours before use.
Reassemble the door on the hinges if you uninstall it
and readjust the airtightness.
28