Floor Firebricks Installation; Firebricks Installation On The Pipes - J. A. Roby CUISINIERE Instruction Manual

Floor firebricks installation

1) Place 2 bricks «A» in the bottom as shown in the picture.
2) After, insert 4 bricks «A» in front of the 2 bricks
previously installed.
3) Insert 1 brick «A» on the right of the ash dump plug.
4) Insert 1 brick «B» on the left of the ash dump plug.
November 5, 2015

Firebricks installation on the pipes

The firebricks must be placed on the 4 pipes from the bottom of
combustion chamber. Bricks keep a maximum heat inside the
combustion chamber so that the air coming from the pipes could
burn the entire gas coming out from wood, which is combustible
only in this way
The rockwool over the brick can prevent considerable leakage
between the bricks and keep a maximum heat inside combustion
chamber. It must cover up all the bricks and the each side of top
of the air corridor.
IMPORTANT: The rockwool must not obstruct the smoke exit.
Verify from the holes on the collar of the chimney to make sure
that it is in the right position. Then, place 2 stainless half round
plate as shown in the picture.
1) Place 2 bricks « A » over the two top pipes so that they
can be aligned lengthwise. Make sure that they are hold
properly on the bricks placed vertically at the back of the
combustible chamber and there is no space between
these bricks.
2) Place 4 bricks « A » over the two front pipes. It must be
placed as shown in the picture below. Be sure to leave
no space in between the bricks previously placed.
12