Opening The Packaging; Content Of The Package - Sonus Faber IL CREMONESE Owner's Manual

OPENING THE PACKAGING

Il Cremonese is packed in a manner that effectively preserves it, while making its removal simple.
We suggest, however, that you follow these general recommendations:
• keep all packaging for any future transport;
• do not wear watches, bracelets, rings etc. in order to avoid scratching the speakers and their precious finishes when
unpacking. The same care will be taken to protect the speakers from any metal finishes on the clothes you are wearing,
such as zips, buttons, belt clasps, rivets, etc.
• open the package following the instructions printed on it.
IMPORTANT: We strongly suggest that the following operations are carried out by no less than two persons.
Moreover, the speaker package should be opened in a place that is as close as possible to the final location of the
speaker in the listening room.
SPECIFIC INDICATIONS
1. remove the protective upper Stratocell layer;
2. remove the protective plastic bag;
3. remove the screws fastening the speaker to the pallet
using the supplied Allen wrench (fig. 1);
4. carefully rotate the speaker (fig. 2);
WARNING! DO NOT grab the speaker from the
aluminium plate and the glass pane on its top.
DO NOT TOUCH the drivers while performing this
operation. (fig. 3);
5. screw in the 3 spikes on the front and on the sides of the
speaker base (fig. 4);

CONTENT OF THE PACKAGE

In addition to the speaker, you will find a box of accessories in the packaging that contains:
• il Cremonese Owner's Manual;
• USB stick;
• 8 spikes and 8 floor disks;
• 4 spike lock nuts;
• 2 front grilles;
INSTALLING THE FRONT AND SIDE GRILLES
The speaker can be fitted with front and grilles, to be found in the accessories box, by carefully following these instructions for the
front and lateral masks:
FRONT GRILLES
1. Insert the pins of the bars of the grille in the relevant
guides, starting from the bottom of the speaker (fig. 8);
2. Stretch the elastic bands of the grill until you are able to
6. tilt the speaker frontwards until the front spike touches
the floor.
WARNING! Place a microfibre cloth or a carpet under
the aluminium base to protect it (fig. 5);
7. screw in the rear spike (fig. 6);
8. remove the speaker from the pallet by pivoting on the
front spike (fig. 7);
9. then put the speaker in its final position in the listening
room.
• 4 side grilles;
• 1 Allen wrench;
• 1 microfibre cloth;
• 1 bottle of detergent;
• 2 dust-proof fabric covers
insert the pins of the grille bars into the relevant guides
in the upper part of the speaker (fig. 9).