Volvo XC90 TWIN ENGINE Owner's Manual page 171

2. Aim the remote control towards the
®
HomeLink button to be programmed and
hold it 2-8 cm from the button. Do not
obstruct the indicator lamp on HomeLink
Note: Some remote controls can program
®
HomeLink better at a distance of 15-20
cm. Bear this in mind if you encounter prob-
lems during programming.
3. Press and hold the button on the original
remote control to be programmed on
®
HomeLink and keep an eye on the indicator
lamp. Do not release the button until the
indicator lamp has switched from flashing
yellow once per second to either flashing
green 10 times per second or illuminating in
a constant green glow. The button on the
remote control can be released once the
indicator lamp flashes or illuminates in green.
Note: For some receivers, programming step
3 may need to be replaced with the instruc-
tions in step 4.
4. Press and release the button on the original
remote control every other second until the
indicator lamp has changed from flashing
yellow once per second to either flashing
green 10 times per second or illuminating in
a constant green glow.
58 Applies to certain markets.
®
59 *" for the location of buttons and indicator lamp.
See section "HomeLink
Button designation and colour vary depending on manufacturer.
60
5. Depress the programmed HomeLink
and check the indicator lamp.
> Constant green glow: If the indicator
®
.
lamp illuminates in a constant green glow,
programming is complete. The garage
door, gate or similar should now be acti-
vated when the programmed button is
depressed.
Flashes green 10 times per second:
Depress the button being programmed,
hold it depressed for 2 seconds and
then release it. Repeat the sequence of
pressing/holding/releasing a second time
and, depending on the receiver model,
even a third time. Programming should
now be complete and the garage door,
gate or similar should now be activated
when the programmed button is
depressed.
If the receiver is still not activated:
Continue with programming steps 6-8 to
complete programming.
INSTRUMENTS AND CONTROLS
®
button
6. Locate programming button
receiver for the garage door or similar. It is
normally located near the antenna bracket on
the receiver.
7. Depress and release the receiver's program-
ming button. Step 8 must be completed
within 30 seconds of the button being
depressed.
8. Depress the button being programmed, hold
it depressed for 2 seconds and then
release it. Repeat the sequence of press-
ing/holding/releasing a second time and,
depending on the receiver model, even a
third time. Programming is now be com-
plete and the garage door, gate or similar
should now be activated when the pro-
grammed button is depressed.
60
on the
}}
169