ECR International G95V Installation Manual And Operating Instructions page 46

TABLE 3 - HEATING CFM
95V060-3
HEAT ADJUST
Jumper Jumper
A NORM
B NORM
C NORM
D NORM
95V080-4
HEAT ADJUST
Jumper Jumper
A NORM
B NORM
C NORM
D NORM
95V120-5
HEAT ADJUST
Jumper Jumper
A NORM
B NORM
C NORM
D NORM
* Motor CFM maxium
95V080-3
HEAT ADJUST
Jumper Jumper
A NORM
B NORM
C NORM
D NORM
* Motor CFM maxium
ESP 0.1" to 1.0" w.c.
Low-Fire High-Fire
CFM CFM
700 1050
850 1105
575 880
525 819
ESP 0.1" to 1.0" w.c.
Low-Fire High-Fire
CFM CFM
1000 1350
1150 1495
900 1206
800 1104
ESP 0.1" to 1.0" w.c.
Low-Fire High-Fire
CFM CFM
1650 2200*
1900 2200*
1500 2070
1325 1815
ESP 0.1" to 1.0" w.c.
Low-Fire High-Fire
CFM CFM
1050 1376
1250 1400*
900 1242
780 1108
95V100-5
HEAT ADJUST
Jumper Jumper
A NORM
B NORM
C NORM
D NORM
Note: Moving the ADJUST jumper from the NORM position to the
(+) or (-) position will increase or lower the temperature rise
by 15%
If the blower speeds require adjustment, follow
these steps:
1. Remove the blower compartment door.
2. Locate the 4 position movable HEAT jumper
to adjust heat speed.
3. Remove the jumper from position A
and place it on the corresponding letter B, C,
or D as required. Refer to TABLE 2 - HEATING
SPEEDS.
NOTE: Temperature rise should always be re-checked
whenever blower speed is changed.
4. To adjust the cooling airflow, remove
the COOL jumper from position A and place
it on the corrosponding letter B, C, or D. Refer
to TABLE 10 AIR FLOW.
Moving the ADJUST jumper from the NORM to
the (+) or (-) position will cause the airflow to be
increased or lowered by 15%.
The TEST position on the ADJUST tap is not
used.
DEHUMIDIFICATION:
For situations where humidity control is a problem,
a dehumidification feature has been built into the
variable speed motor. At the start of each cooling
cycle, the variable speed motor will run at 82% of
the rated airflow for 7.5 minutes. After 7.5 minutes
has elapsed, the motor will increase to 100% of the
rated airflow. If this feature is not desired, clip the
jumper wire between Y and O on the integrated fur-
nace control board. With Y and O not jumpered, the
variable speed will reach 100% of the rated airflow
within 10 seconds of a call for cooling.
46
ESP 0.1" to 1.0" w.c.
Low-Fire High-Fire
CFM CFM
1200 1620
1400 1820
1100 1474
950 1349