ECR International G95V Installation Manual And Operating Instructions page 3

! WARNING
IF THE INFORMATION IN THESE INSTRUC-
TIONS IS NOT FOLLOWED EXACTLY, A FIRE
OR EXPLOSION MAY RESULT, CAUSING
PROPERTY DAMAGE, PERSONAL INJURY
OR LOSS OF LIFE.
!
WARNING
THIS PRODUCT MUST BE INSTALLED BY
A LICENSED PLUMBER OR GAS FITTER
WHEN INSTALLED WITHIN THE COMMON-
WEALTH OF MASSACHUSETTS.
!
WARNING
FOR YOUR SAFETY
DO NOT STORE OR USE GASOLINE OR OTH-
ER FLAMMABLE VAPORS AND LIQUIDS, OR
OTHER COMBUSTIBLE MATERIALS IN THE VI-
CINITY OF THIS OR ANY OTHER APPLIANCE.
WHAT TO DO IF YOU SMELL GAS
• DO NOT TRY TO LIGHT ANY APPLIANCE.
• DO NOT TOUCH ANY ELECTRICAL
SWITCH; DO NOT USE ANY PHONE IN
YOUR BUILDING.
• IMMEDIATELY CALL YOUR GAS SUP-
PLIER FROM A NEIGHBOR'S PHONE,
OR A CELLULAR PHONE FROM A LO-
CATION WELL AWAY FROM THE BUILD-
ING. FOLLOW THE GAS SUPPLIER'S
INSTRUCTIONS.
• IF YOU CANNOT REACH YOUR GAS SUP-
PLIER, CALL THE FIRE DEPARTMENT.
• DO NOT RE-ENTER THE BUILDING UN-
TIL AUTHORIZED TO DO SO BY THE GAS
SUPPLIER OR THE FIRE DEPARTMENT.
IMPROPER INSTALLATION, ADJUSTMENT,
ALTERATION, SERVICE OR MAINTENANCE
CAN CAUSE INJURY, PROPERTY DAMAGE
OR LOSS OF LIFE. REFER TO THIS MANUAL.
INSTALLATION AND SERVICE MUST BE
PERFORMED BY A QUALIFIED INSTALLER,
SERVICE AGENCY OR THE GAS SUPPLIER.
!
!
!
1. Use this furnace only with type of gas approved
for this furnace. Refer to the furnace rating plate.
2. Install this furnace only in dry indoor locations
(protected from weather).
3. Provide adequate combustion and ventilation air
to the furnace space as specified in Section 7 of this
manual, "Ventilation and Combustion Air."
4. Combustion products must be discharged out-
doors. Connect this furnace to an approved vent
system only, as specified in Section 8 of this manu-
al, "Venting and Combustion Air Piping."
5. Never test for gas leaks with an open flame. Use
a commercially available soap solution made spe-
cifically for the detection of leaks to check all con-
nections as specified in Section 14 of this manual,
"Gas Supply and Piping."
6. Always install furnace to operate within the fur-
nace's intended temperature-rise range with a duct
system, which has an external static pressure with-
in the allowable range, as specified in Sections 3,
6, and 20 of this manual, "Furnace Sizing," "Duct-
work," and "Airflow."
7. When a furnace is installed so that the supply
ducts carry air circulated by the furnace to areas
outside the space containing the furnace, the return
air shall also be handled by duct(s) sealed to the fur-
nace casing and terminating outside the space con-
taining the furnace. (Furnace for heating the home
located in the attached garage, for example).
3
! WARNING
THESE INSTRUCTIONS ARE INTENDED AS
AN AID TO QUALIFIED SERVICE PERSON-
NEL FOR PROPER INSTALLATION, ADJUST-
MENT AND OPERATION OF THIS FURNACE.
READ THESE INSTRUCTIONS THOROUGHLY
BEFORE ATTEMPTING INSTALLATION OR
OPERATION. FAILURE TO FOLLOW THESE
INSTRUCTIONS MAY RESULT IN IMPROPER
INSTALLATION, ADJUSTMENT, SERVICE OR
MAINTENANCE, POSSIBLY RESULTING IN
FIRE, ELECTRICAL SHOCK, CARBON MON-
OXIDE POISONING, EXPLOSION, PROPERTY
DAMAGE, PERSONAL INJURY OR DEATH.
SAFETY RULES
!