Updating Of The Firmware - Pioneer XV-BD122B Service Manual

1

8.2 UPDATING OF THE FIRMWARE

A
Firmware Update
This unit has four firmwares. (MPEG, SERVO, DSP and MCU)
You can update all firmwares at the same time by copying them into one USB memory.
• MPEG firmware
BCS727_V00.**.bin
(** is Version Number of MPEG Firmware)
DLdiscidentifier.txt
• SERVO firmware
DVD.bin
B (*) The required time for Firmware Update
MPEG firmware (SERVO firmware): About 30 seconds to 1 minutes
DSP firmware: About 10 to 12 minutes
MCU firmware: About 3 to 5 minutes
[1] Before Firmware Update, please check the current
firmware version installed in this unit.
Please refer to "How to confirm the versions".
C
[2] Please copy the updating file into the USB memory
route path.
(*) New SERVO firmware and DSP firmware may not be
released in the future. Then, please copy MPEG
firmware and MCU firmware (BCS727_V00.**.bin,
DLdiscidentifier.txt, BCS727_MCU.bin,
DLdiscidentifier_MCU.txt) into the USB memory.
[3] After step 2, please insert the USB memory into unit
and turn Power ON. Please press "HOME NENU"
button to enter the menu, after that, please select
"Home Menu" ⇒ "Initial Setup" ⇒ "Options" ⇒
D
"Update" ⇒ "USB Storage".
[4] Fig. 2 is displayed after displaying Fig.1. Then,
firmware update starts by pressing ENTER button.
(*) Never press any buttons on Remote Control or Front
Panel until finishing the update.
E
F
[5] Firmware update is executed by the following sequence.
MPEG firmware + SERVO firmware ⇒
DSP firmware ⇒ MCU firmware
30
1
2
Fig. 1
Fig. 2
XV-BD422B
2
3
• DSP firmware
BCS727_DSP.bin
• MCU firmware
BCS727_MCU.bin
DLdiscidentifier_MCU.txt
[6] When the update for MPEG firmware starts, the
following GUI is displayed. Then "MPEG UPG" is
displayed on FL tube. If there is SERVO firmware in
USB memory, SERVO firmware is updated at same time.
Fig. 3
[7] After finishing the update for MPEG firmware, the
update for DSP firmware starts automatically. Then,
the following GUI is displayed and "DSP UPG" is
displayed on FL tube. If there isn't DSP firmware in
USB memory, the update for DSP firmware will be skipped.
Fig. 4
[8] After finishing the update for DSP firmware, the update
for MCU firmware starts automatically. Then, the
following screen is displayed and "MCU UPG" is
displayed on FL tube.
Fig. 5
3
4
4