Pioneer XV-BD122B Service Manual page 31

5
Attention
The update for MCU Firmware doesn't finish fairly
infrequently. If it doesn't finish after 10 minutes, please
execute firmware update again by the following procedure.
1 Unplug Power cord.
2 Plug Power cord again and press "STANDBY/ON" button.
3 When this unit turns power on, the following message is
displayed on screen. Please execute firmware update again.
Fig. 6
[9] After finishing the update for MCU firmware, the following
message is displayed. This unit reboots automatically
after 5 seconds. After reboot, firmware update finishes.
Please confirm the firmware version in this unit.
Fig. 7
How to confirm the versions
You can press "HOME MENU" button to enter the menu, after that, press "i/j/k/l " buttons to display "Home Menu" ⇒
"Initial Setup" ⇒ "Options" ⇒ "System Information", then you can see the information of current firmware version by pressing
the "ENTER" button.
(*) How to confirm SERVO firmware
Only as for SERVO firmware, a version confirmation method differs. With the Initial Setup screen displayed, press the numeric
buttons "8" ⇒ "5" ⇒ "2" ⇒ "0". Then BUDA Information is displayed on screen.
5
6
MPEG firmware version
MCU firmware version
DSP firmware version
SERVO firmware version
XV-BD422B
6
7
7
8
A
B
C
D
E
F
31
8