Table of Contents
Advertisement
When tape jammed is happened
1) When operating by manual mode, tape doesn't come properly even if pressing START BUTTON.
2) When operating by auto mode, the next tape doesn't come even if taking the tape ready.
3) Tape doesn't come even if you hear the sound of motor working.
Please take the following procedure when you find the problems as mentioned above.
◆Open HOLD DOWN ROLLER UNIT.
◆While pressing REV BUTTON, please pull the tape out backward.
◆Remove BLADE UNIT after switching off and removing power
cord from the machine.
Then check the inside of the machine and remove something if
you find some waste of tapes on the ROLLERS or BLADE UNIT.
◆Install BLADE UNIT into the body.
◆Connect POWER CORD to machine and switch on.
◆Take a proper procedure and set your tape accordingly.
In the operation procedure as mentioned above, please take
the following steps if you can't pull a tape from machine.
◆Open UPPER CASE.
1) Pull Upper Case backward (2mm).
2) Lift UPPER CASE up while pulling it.
◆Connect POWER CORD to machine and switch on.
(When opening UPPER CASE, operating board for folding
function can move only for operation check.)
◆Press FOLDING OPERATION CHECK SWITCH more than 1 sec.
(Stop automatically to the maximum tape outlet position.)
◆Remove the waste of tape jammed by using tweezers.
◆Press FOLDING OPERATION CHECK SWITCH once again
more than 1 sec.
(Stop automatically to the original position.)
◆Close UPPER CASE and install BLADE UNIT into the body.
◆Take a proper procedure and set your tape accordingly.
Error Messages
The buzzer will has a sound then a message will flash and show on the
DISPLAY.
E-02 Blade is Out of Position
A signal shows that the blade is not installed well or machine stops because
of the thickness or hardness of the tape.
◆Turn the POWER SWITCH off.
◆Remove the BLADE UNIT by releasing the BLADE UNIT RELEASING
LEVER then lift the assembly out of the body.
◆Turn the POWER SWITCH on.
◆Press the FWD BUTTON and feed -in the tape once, cut the tape in between
the TAPE OUTLET and the BLADE UNIT by scissor.
◆Press the REV BUTTON to remove the tape.
◆Clean the BLADE UNIT and lubricate the LOWER BLADE GUIDE.
◆Check the lower blade position and replace the BLADE UNIT.
12
APPER CASE
FOLDING OPERATION CHECK SWITCH
POWER SWITCH IS OFF
REMOVE BLADE UNIT
POWER SWITCH IS ON
CLEAR THE ERROR
START
FEED THE TAPE
FWD
REMOVE THE TAPE
REV
CLEAR THE BLADE
SET THE TAPE
Hide quick links:
Advertisement
Table of Contents
