Other Functions - Yaesu ZCUT-10 Instruction Manual

How to Manage a Curling Tape
◆Press the HOLD DOWN ROLLER RELEASE BUTTON in order to open
the HOLD DOWN ROLLER UNIT.
◆Extend the ROLLER LOCK LEVER so that the roller will not turn.
◆Close the HOLD DOWN ROLLER UNIT.
With the rollers locked, the tension may cause the length to vary.
Cut several test pieces in order to adjust the length if needed..
Use Narrow Tape / Use Two Rolls in a Same Time
If the tape is lesser than 25 mm width or you want to dispense two rolls in a
same time, use the SEPARATOR.
Cut lesser than 10 mm width of tape, put the GUIDE PLATE on the SEPA-
RATOR.
◆Remove the SEPARATOR from the bottom of body.
◆Open the HOLD DOWN ROLLER UNIT.
◆Insert the SEPARATOR into the body by slotting in to the bottom of the cavity.
◆When you cut the tape lesser than 10 mm, put the GUIDE PLATE onto the
Separator.
◆Place one roll of the tape or either side by inserting a SEPARATOR for
loading tape.
◆To hold the tape by adjusting TAPE HOLDERS, it is unnecessary to push
the SEPARATOR out of position.
When dispensing two roll of tapes in a same time, it is a must to feed-in
both of its' length in a same time.
◆Remove the first piece of tape.
◆When the second piece of the tape is removed, both side of tapes are also
dispensed.

Other Functions

FLEXIBLE TAPE SUPPORT
When you cut the tape longer or cut
non-adhesive tape / film, use FLEX-
IBLE TAPE SUPPORT in order to
avoid the tape fall down.
10
ASSIST STAND
Based on the tape material
or workpiece purpose, use
the ASSIST STAND in order
to let the body of machine
towards a lower level.
GUIDE PLATE
SEPARATOR