Table of Contents
Advertisement
E-03 Motor is Stopped
Indicates that the motor is stopped because of overload.
◆Press the START BUTTON to clear the error message.
◆Press the REV BUTTON to remove the tape.
◆Turn the POWER SWITCH off.
◆Check the BLADE UNIT and TAPE OUTLET carefully.
◆Clear and take away the spare tape waste or sticky residue by using
tweezers.(Clean ROLLER UNIT as depens on the condition.)
E-04 Motor Position Error for Folding Function
This is likely to happen when motor is overloaded and stopped.
◆Remove BLADE UNIT.
◆Switch off and remove POWER CORD from the machine.
(When tape is jammed, please refer to "When tape jammed is happened"
and open UPPER CASE.)
◆Push POWER CORD into machine and switch on.
(In the case of opening UPPER CASE, FOLDING OPERATION CHECK
SWITCH is only moved.)
◆Press FOLDING OPERATION CHECK SWITCH more than 1 sec.
(Stop automatically to the maximum tape outlet position.)
◆Remove the waste of tape jammed by using tweezers.
◆Press FOLDING OPERATION CHECK SWITCH once again more than 1 sec.
(Stop automatically to the original position.)
◆Close UPPER CASE.
(Operating board turns on electricity and resumes operating.)
◆Pull your tape backward while pressing REV BUTTON.
◆Install BLADE UNIT into the body.
◆Take a proper procedure and set your tape accordingly.
Do not touch the Blade when you are correcting an error under POWER SWITCH
is on.
Turn off the POWER SWITCH and stop using the machine.
If the machine cannot work normally after correcting the error.
It seems that nothing wrong without any error messages.
Do not use the tape if static electricity generates over 1000V.
It may cause failure to the machine.
CLEAR THE ERROR
START
REMOVE THE TAPE
REV
SET THE TAPE
REMOVING BLADE UNIT
OPEN UPPER CASE
FOLDING OPERATION
CHECK SWITCH
Pressing more
than 1 second
REMOVE THE WASTE
OF TAPE JAMMED
FOLDING OPERATION
CHECK SWITCH
Pressing more
than 1 second
CLOSE UPPER CASE
INSTALL BLADE UNIT
SET A TAPE
13
Hide quick links:
Advertisement
Table of Contents
