Honeywell FS20X Series Installation Manual And Operating Manual page 15

B efore completing the installation
U
application. The FSX Detectors Factory Default Settings are:
Alarm Relay Outputs are Non-Latching and Normally De-Energized
Detector Range / Sensitivity is Medium
Auxiliary Relay Verify Time is set to 5 Seconds
FACTORY USE ONLY
Fault Relay Output is Normally Energized
Communication is set to FireBus
Factory Use Only
Digital Communication Address is set to 127
If the application for the Detector requires different settings, refer to Section 3.2 for detailed descriptions.
U
Before applying 24 VDC power to the Detector, make sure
1. Wire connections are correct (Section 2.3). Each wire must be stripped properly to the correct length,
loose wire strands must be removed and each wire must be securely and firmly screwed clockwise in
the connector.
2. If using conduit, ensure a proper conduit seal, (appropriate for the area classification), has been
installed and
3. Consult the manufacturer for dimensional information on the flameproof joint specifications.
4. The FSX Detector is securely mounted and has an unobstructed view of the area of coverage
(Section 2.1).
5. The Detector window is unobstructed and clean,
6. To ensure optimum performance, shield the detector face from intense bright light sources when first
energized.
The Detector is now ready for Power-Up.
Default Setting is used (Section 3.2).
Honeywell
Installation Guide and Operating Manual // Model FS20X™ Series
, check that the Detector is configured correctly for the specific
U
II
a ll measures to prevent moisture ingress have been taken
U
O n Power-Up, the Fault Relay will change status if the Factory
U
SW2-1 OFF
SW2-2 OFF
SW2-4 ON
SW3 is set to Position 4
SW1-1 through SW1-3 OFF
SW1-4 through SW1-10 ON
:
U
.
U
SW2-7 OFF
SW2-3 ON
SW2-5 ON
SW2-6 OFF
SW2-8 ON
13