Table of Contents
Advertisement
STOVE ASSEMBLY
PRIOR TO
INSTALLATION
The F3502B unit requires the pedestal attached
to the base. The F3502B stove requires either
the Airmate or Rear Heat Deflector on top of
the stove. Clearances to combustible materials
vary depending on whether the airmate or rear
heat deflector is installed, so be sure to check
the Minimum Clearances, Installation section.
Airmate Assembly for F3502B
1) The airmate sits on top of the stove with
the slots in the sides fitting over the curved
deflector on the rear stove top. See diagram
1. Discard the Rear Heat Deflector that is
supplied with the unit, it is not required if the
airmate is installed.
2) Center the airmate and push it forward to the
front of the stove. The back of the airmate
should be level with the back and sides of
the rear heat shield. See Diagrams 2 & 3.
Airmate
Side
Shield
Stove
Diagram 1
Diagram 2
Diagram 3
Rear Heat Deflector
Assembly for F3502B
The rear heat deflector is supplied with the stove
and must be installed unless the optional airmate
has been selected. It stops the heat radiated
from the flue collar from overheating the rear
wall. The rear heat deflector is installed on top of
the rear heat shield, as shown in Diagram 4.
Side View
Diagram 4
Side Shield Adjustment
The left and right side shields are lowered for ship-
ping and handling. It allows for a handhold on the
top of the stove. Before placing in the Step Stove
in its final position, the side shields must be raised.
Rear Heat
Loosen the screws on the rear on the stove (3 per
Shield
side), slide the side panel up as far as possible and
then secure by tightening the screws.
Screws
Rear Heat Deflector
installation
Logo Installation
1) Push the
Regency logo
into the two
holes in the
front bottom left
corner of the
pedestal cover
plate.
Note: Any paint touch up should be done
prior to placing logo on pedestal.
2) If not using ash drawer, then cover plate must
be installed.
F3502B Freestanding Woodfire |
|
7
7
Advertisement
Table of Contents
